[20:18:39] Cruising at 32000ft, pitch: 2, 478 kts
[21:14:36] Simulation rate set to 4X
[22:20:34] Simulation rate set to normal
[22:51:41] Simulation rate set to 4X
[22:54:20] Simulation rate set to normal
[04:07:59] Simulation rate set to 4X
[04:08:05] Simulation rate set to normal
[04:37:59] Flight restored from Premium
[04:37:59] Sim paused
[04:38:12] Sim unpaused
[04:38:13] Overspeed entered
[04:38:19] Sim paused
[04:38:23] Sim unpaused
[04:38:55] Overspeed left after a max speed of 359 kts
[04:40:04] Sim paused
[04:40:06] Flaps set to position 1 at 32923 ft at 291 kts
[04:40:11] Sim unpaused
[04:40:17] Flaps set to position 0 at 32841 ft at 285 kts
[04:42:00] Simulation rate set to 4X
[04:42:55] Sim paused
[04:43:01] Sim unpaused
[04:44:10] Simulation rate set to normal
[04:44:26] Descending
[04:58:04] Approaching
[04:58:23] Sim paused
[04:58:25] Flaps set to position 1 at 9579 ft at 228 kts
[04:58:25] Sim unpaused
[05:00:29] Flaps set to position 3 at 5715 ft at 200 kts
[05:01:33] Gear lever lowered at 4740 ft at 175 kts
[05:01:59] Flaps set to position 5 at 4173 ft at 140 kts
[05:03:02] Final approach, 141 kts
[05:06:45] Sim paused
[05:07:21] Sim unpaused
Landing
Click to expand/close
[05:08:15] Touched down at -156 fpm, gear lever: down, pitch: 4, roll: level, 116 kts
[05:08:54] Landed in 3493 ft, fuel: 72338 lb, weight: 774343 lb
[05:08:54] Taxiing to gate
[05:09:39] Flaps set to position 0
[05:10:33] Flaps set to position 5
[05:11:20] Sim paused
[05:11:22] Flaps set to position 0
[05:11:22] Sim unpaused
[05:15:45] The flight may now be ended
[05:15:45] Arrived, flight duration: 12:40
[05:17:09] Engine 1 is off
[05:17:10] Engine 2 is off
[05:17:11] Engine 3 is off
[05:17:12] Engine 4 is off
i\'m not sure why this happens, but on my climb up to 32,000 feet I left the aircraft unattended in managed mode. Thinking everything would be fine, when i came back the aircraft had decided to pitch up about 25 degrees, and was pasued in the stall. This is a freeware A380 so i suppose the autopilot system isnt the best. This also explains the overspeed, as the speed was in managed mode but a glitch in the software caused the speed to fly by the desired number.
-Chris Reisinger
Your PIREP is pending due to the following criteria found in your log: A stall was detected
-PIREP Bot