SmartCARS Log
smartCARS version 2.1.35.4, 2023/8/12 UTC
[02:06:26] Preflight started, flying offline
[02:06:26] Flying Project Opensky Boeing 737-800WL American Airlines N908NN
[02:06:26] Sim paused
[02:06:33] Sim unpaused
[02:06:34] Pushing back with 38451 lb of fuel
[02:09:31] Engine 1 is on
[02:09:56] Engine 2 is on
[02:10:04] Flaps set to position 3
[02:10:26] Taxiing to runway
[02:11:36] Taking off
[02:11:37] Rejected takeoff conditions met, returning to taxiing phase
[02:13:57] Taking off
[02:14:21] Climbing, pitch: 2, roll: level, 196 kts
[02:14:27] Gear lever raised at 141 ft at 211 kts
[02:14:47] Flaps set to position 6 at 960 ft at 212 kts
[02:16:39] Flaps set to position 1 at 5473 ft at 249 kts
[02:16:41] Flaps set to position 0 at 5559 ft at 252 kts
[02:16:44] Exceeded 250 KIAS below 10,000 feet MSL
[02:17:19] Speed corrected at 7668 ft after a max speed of 283 kts
[02:32:21] Cruising at 36000ft, pitch: 6, 377 kts
[02:33:37] Simulation rate set to 4X
[02:53:15] Sim paused
[02:53:22] Simulation rate set to normal
[02:53:25] Sim unpaused
[02:53:32] Descending
[03:00:56] Sim paused
[18:01:39] Sim unpaused
[18:11:18] Approaching
[18:16:41] Sim paused
[18:22:44] Sim unpaused
[18:27:16] Flaps set to position 2 at 3869 ft at 220 kts
[18:29:29] Final approach, 215 kts
[18:29:47] Gear lever lowered at 2063 ft at 216 kts
[18:31:02] Flaps set to position 7 at 695 ft at 223 kts
[18:31:05] Flaps set to position 8 at 653 ft at 219 kts
[18:31:55] Go around conditions met
[18:31:57] Standard final approach conditions met
[18:32:13] Touched down at -204 fpm, gear lever: down, pitch: 7, roll: level, 126 kts
[18:32:15] Aircraft bounced, touched back down at -31 fpm
[18:32:36] Flaps set to position 3
[18:32:36] Flaps set to position 0
[18:32:37] Landed in 3545 ft, fuel: 20581 lb, weight: 150764 lb
[18:32:37] Taxiing to gate
[18:32:43] The flight may now be ended
[18:32:43] Taxi time was less than 15 seconds
[18:32:43] Arrived, flight duration: 02:17
[18:33:21] Engine 1 is off
[18:33:23] Engine 2 is off
[18:33:30] Sim paused
No comments have been left on this report.